For 1990-2009 cars only
Removal Procedure
- Relieve the fuel system pressure before servicing any fuel system connection. Refer to Fuel Pressure Relief.
- Using compressed air, blow any dirt out of the quick-connect fitting.
- Squeeze the plastic retainer release tabs.
- Pull the connection apart.
Warning: Wear safety glasses when using compressed air in order to prevent eye injury.
Installation Procedure
- Apply a few drops of clean engine oil to the male fuel pipe end.
- Push both sides of the quick-connect fitting together in order to cause the retaining tabs to snap into place.
- Once installed, pull on both sides of the quick-connect fitting in order to make sure the connection is secure.
Warning: Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
