GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Kodiak C-Series (Conventional) C6/C7/C8 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Electronic Brake Control Module Replacement

Removal Procedure

    Warning: Refer to Battery Disconnect Warning in the Preface section.

  1. Disconnect the negative battery cable.

    2. Object Number: 1500652 Size: SH
  2. Remove the electrical connector bolt from electronic brake control module (EBCM).
  3. Disconnect the electrical connector from EBCM.
  4. Remove the 4 bolts and 4 washers and remove the EBCM from the bracket.

Installation Procedure

    Object Number: 1500652 Size: SH
  1. Install EBCM to bracket.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the 4 EBCM mounting bolts and washers.

    3. Tighten
    Tighten the EBCM mounting bolts to 8 N·m (71 lb in).

  3. Connect the EBCM electrical connector.
  4. Install the EBCM electrical connector bolt.

    5. Tighten
    Tighten the EBCM electrical connector bolt to 2 N·m (18 lb in).

  5. Connect the negative battery cable.
  6. Perform the diagnostic system check.
  7. Refer to Control Module References for programming and setup information.