GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Suspension Controls Schematics

Connector End View Reference: Suspension Controls Connector End Views

1

Did you review the system and circuit description and perform the necessary inspections?

Go to Step 2

Go to Symptoms - Air Suspension

2

Verify the fault is present.

Does the system operate normally?

Go to Testing for Electrical Intermittents in Wiring Systems

Go to Step 3

3

  1. Disconnect the air suspension dump switch connector.
  2. Connect a test lamp between the air suspension dump indicator control circuit and ground circuit.
  3. Turn the ignition ON, with the engine OFF.

Does the test lamp illuminate?

Go to Step 7

Go to Step 4

4

Inspect the air suspension dump indicator control circuit for poor connections at the IP harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 8

Go to Step 5

5

Check the air suspension dump indicator control circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 8

Go to Step 6

6

Check the air suspension dump indicator ground circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 8

--

7

Replace the air suspension dump switch.

Did you complete the replacement?

Go to Step 8

--

8

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3