Illuminated entry lights remain on.
Interference between the outside handle to lock rod and lever on the outside handle. Refer to Figure 1.
1. Remove trim panel.
2. Remove water deflector.
3. Disengage retaining clip at lower end of the outside handle to lock rod and remove rod.
4. Remove two retaining nuts on outside handle and remove from door.
5. File radius as shown in Figure 2.
6. De-burr the inside edges of the handle where the rod fits through, sand all surfaces smooth that were filed.
7. Touch up all filed surfaces to stop corrosion, this will also insure proper operation.
8. Reinstall door handle.
9. Reinstall outside handle to lock rod by adjusting nut on lower end of rod until knob of attaching nut is between one and two turns lower than the hole in the lever of the lock, snap nut into hole and engage clip onto lever and rod assemble.
10. Check for proper operation, reinstall water deflector and trim panel.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.