FRT/REAR DOORS BIND W/OPENING (SERVICE PROCEDURE)

Subject: FRONT/REAR DOORS BIND WHEN OPENING

Model and Year: 1990-92 LUMINA

THIS BULLETIN CANCELS AND SUPERSEDES DEALER SERVICE BULLETIN NO. 90-43-10, DATED AUGUST 1989. THE 1991-92 MODEL YEARS HAVE BEEN ADDED. ALL COPIES OF 90-43-10 SHOULD BE DISCARDED.

CONDITION:

---------- The condition may be caused by interference of the door upper frame to the auxiliary seal strip along the roof.

CORRECTION:

----------- This condition may be addressed by using a hammer and a block of wood, bend the auxiliary seal strip mounting flange slightly downward to:

- relieve the interference in affected area but, - not create a gap for wind noise.

It is not necessary to remove the seal strip from the flange for this repair. See Figure 1.

LABOR OPERATION: T-150O Right Side T-1501 Left Side

LABOR TIME: .3 Hours

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.