DOOR TRIM GAP AT BOTTOM OF PAD REPOSITION DOOR TRIM PAD

SUBJECT: DOOR TRIM GAP (REPOSITION TRIM PAD/REINSTALL)

VEHICLES AFFECTED: 1992 CHEVROLET LUMINA COUPE

Condition:

----------- Owners of some 1992 Chevrolet Lumina coupes may comment about a gap at the bottom centre of either door trim pad. The gap is just below the seat belt shoulder harness retractor location.

Cause:

------- Trim pad not held in position while retaining screw is being driven.

Correction:

------------ 1. Remove lower attaching screw. 2. Move trim pad forward by pushing on lower trailing edge closing gap. 3. Drill a new 1/8" hole in the door inner panel using the repositioned trim pad hole as a guide, and reinstall trim screw.

Use the most applicable Labour Operation and Time from the Canadian Labour Time Guide.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.