Oil Cooler Hose/Pipe Replacement Inlet Hose

1. Drain the cooling system. Refer to SECTION 6B.
2. Raise the vehicle. Support the vehicle suitably.
3. Place the drain pan under the engine in order to catch any fluids that may drain.
4. Remove the oil filter.



5. Disconnect the inlet hose from the oil cooler.
6. Disconnect the inlet hose from the block fitting.
7. Remove the inlet hose.

1. Install the inlet hose.
2. Connect the inlet hose to the block fitting.
3. Connect the inlet hose to the oil cooler.
4. Install the oil filter. Lubricate the seal with engine oil.

Tighten
Hand tighten the filter to 13 N·m (115 lb in).

5. Lower the vehicle.
6. Refill the coolant system. Refer to SECTION 6B.
7. Add engine oil as necessary.
8. Inspect for leaks if necessary.

Oil Cooler Hose/Pipe Replacement Outlet Hose

1. Drain the cooling system. Refer to SECTION 6B.
2. Raise the vehicle. Support the vehicle suitably.



3. Disconnect the outlet hose from the oil cooler.
4. Disconnect the outlet hose from the heater pipe.
5. Remove the outlet hose.

1. Install the outlet hose.
2. Connect the outlet hose to the heater pipe.
3. Connect the outlet hose to the oil cooler.
4. Lower the vehicle.
5. Refill the coolant system. Refer to SECTION 6B.