Tools Required

J 33049 Camshaft Bearing Remover/Installer

1. Select the proper front, rear, and middle intermediate shaft bearings.
2. Select the proper expander assembly and the proper driving washer.
3. Assemble the J 33049 .
4. Place the middle intermediate shaft bearing onto the J 33049 .
5. Index the hole at the 4 o'clock position when looking at the front of the engine block.
6. Drive the intermediate shaft bearings into place.

Notice: Severe engine damage may result if the oil holes are not correctly aligned.

7. Use the J 33049 in order to install the number 4 intermediate shaft bearing with the oil hole indexed at 4 o'clock when looking at the front of the engine.
8. Use the J 33049 in order to install the number1 intermediate shaft bearing with the oil hole indexed at 4 and 7 o'clock when looking at the front of the engine block.
9. Use a piece of 3/32 inch brass rod with a 90° bend at the end in order to probe the bearing oil holes and verify that the oil holes are properly aligned.



10. Install the intermediate shaft cup plug.