For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Refer to General Vehicle Lifting and Jacking in General Information.
- Support the vehicle on a suitable stand.
- Refer to Wheel Removal in Tires and Wheels in order to remove the right front tire.
- Remove the engine splash shield.
- Remove the drive axle shield.
- Disconnect the speed sensor electrical connector.
- Remove the bolt.
- Remove the speed sensor from the extension case.
- Remove the O-ring from the speed sensor.
Installation Procedure
- Install the O-ring to the speed sensor.
- Install the speed sensor to the extension case.
- Install the bolt.
- Connect the speed sensor electrical connector.
- Install the drive axle shield.
- Install the engine splash shield.
- Refer to Tire Removal in Tires and Wheels in order to install the right front tire.
- Lower the vehicle.
Tighten
Tighten the bolt to 11 N·m (97 lb in).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
