GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1996 🢒 Lumina 🢒 Transmission/Transaxle 🢒 Automatic Transaxle - 4T60-E 🢒 Oil Pan Replacement

Removal Procedure
  1. Inspect the washers on the bolts when the following procedures must be done:
    2. 1.1. Side case cover removal
    1.2. Oil pan removal
  2. If the washer is inverted, do the following:
    3. 2.1. Install a new bolt.
    2.2. Install a new washer.
  3. Raise the vehicle. Refer to General Vehicle Lifting and Jacking in General Information.
  4. Support the vehicle with a suitable stand.

    5. Object Number: 99867 Size: SH
  5. Position the drain pan under the vehicle.
  6. Loosen the pan bolts.
  7. Drain the fluid.
  8. Remove the pan attaching the bolts.
  9. Remove the pan.
  10. Remove the gasket.

Installation Procedure

    Object Number: 99867 Size: SH
  1. Install the pan.
  2. Install a new gasket.
  3. Install the attaching bolts.

    4. Tighten
    Tighten the bolts to 17 N·m (13 lb ft).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Drain the pan.
  5. Lower the vehicle.
  6. Adjust the fluid level.