GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Lumina 🢒 Engine 🢒 Engine Controls - 3.1L (LG8) 🢒 Evaporator Tube Replacement

Removal Procedure
  1. Remove the air cleaner and duct assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.1L.
  2. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  3. Remove the brake modulator/master cylinder. Refer to Brake Modulator/Master Cylinder Assembly Replacement in Antilock Brake System.

    4. Object Number: 491758 Size: SH
  4. Remove the liquid line/suction line bracket.

    5. Object Number: 406231 Size: SH
  5. Remove the liquid line nut (1) at the orifice.

    6. Object Number: 412855 Size: SH
  6. Remove the liquid line block fitting bolt and the liquid line.

    7. Important: Use care when removing the liquid line.

  7. Remove the liquid line.
  8. Remove the O-rings and discard.

Installation Procedure

    Important: The new O-ring seals must be lubricated with mineral base 525 viscosity refrigerant oil.

  1. Install the new O-ring seals onto the evaporator liquid line. Refer to O-Ring Replacement .
  2. Install the liquid line into place.

    3. Object Number: 412855 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the liquid line at the block fitting.

    4. Tighten
    Tighten the liquid line block fitting bolt to 16 N·m (12 lb ft).


    Object Number: 406231 Size: SH
  4. Install the liquid line nut (1) at the orifice.

    5. Tighten
    Tighten the liquid line nut to 27 N·m (20 lb ft).


    Object Number: 491758 Size: SH
  5. Install the liquid/suction line bracket.
  6. Install the brake modulator/master cylinder. Refer to Brake Modulator/Master Cylinder Assembly Replacement in Antilock Brake System.
  7. Evacuate and charge the system. Refer to Refrigerant Recovery and Recharging .
  8. Inspect the system for leaks. Refer to Leak Testing .
  9. Install the air cleaner and duct assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls -3.1L.