GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Lumina 🢒 Engine 🢒 Engine Electrical 🢒 Wheel Speed Sensor Jumper Harness Replacement

Wheel Speed Sensor Jumper Harness Replacement Front

Removal Procedure

    Object Number: 155156 Size: SH
  1. Disconnect the front wheel speed sensor jumper harness to ABS harness connector (8).
  2. Raise and support the vehicle on a suitable hoist. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the harness (4) from the splash shield retaining clip (5).
  4. Remove the harness (4) from the control arm retaining clips (3).
  5. Disconnect the front wheel speed jumper harness connector from the front wheel sensor.
  6. Remove the front wheel speed sensor jumper harness.

Installation Procedure
  1. Connect the front wheel speed sensor jumper harness connector to the wheel speed sensor.

    2. Object Number: 155156 Size: SH
  2. Install the harness (4) to control arm retaining clips (3).
  3. Install the harness (4) to splash shield retaining clip (5).
  4. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Connect the front wheel speed sensor jumper harness to ABS harness connector (8).
  6. Turn the ignition switch to the ON position, with the engine off.
  7. Perform the Diagnosis System Check. Refer to Diagnostic System Check - ABS .

Wheel Speed Sensor Jumper Harness Replacement Rear

Removal Procedure

    Object Number: 230413 Size: SH
  1. Raise and support the vehicle on a suitable hoist. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the rear wheel speed jumper harness connector at the pass thru connector.
  3. Remove the rear wheel speed sensor jumper harness from the retaining clips.

    4. Object Number: 305363 Size: SH
  4. Disconnect the rear wheel speed sensor jumper harness connector (1) from the wheel speed sensor, located next to rear strut (2).
  5. Remove the rear wheel speed sensor jumper harness.

Installation Procedure

    Object Number: 305363 Size: SH
  1. Connect the rear wheel speed sensor jumper harness connector (1) to the wheel speed sensor, located next to rear strut (2).

    2. Object Number: 230413 Size: SH
  2. Install the rear wheel speed jumper harness (1) into the retaining clips (2).
  3. Connect the rear wheel speed sensor jumper harness connector to the pass thru connector.
  4. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Turn the ignition switch to the ON position, do not start engine.
  6. Perform the Diagnosis System Check. Refer to Diagnostic System Check - ABS .