GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Lumina 🢒 Suspension 🢒 Rear Suspension 🢒 Stabilizer Shaft Link Replacement

Removal Procedure

    Object Number: 176752 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the stabilizer shaft link bolt (5).
  3. Separate the bracket and remove the insulator.

Installation Procedure

    Object Number: 176752 Size: SH
  1. Install the insulator and the stabilizer link to the stabilizer shaft.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the stabilizer shift link bolt (5).

    3. Tighten
    Tighten the stabilizer shaft link bolt to 70 N·m (52 lb  ft).

  3. Lower the vehicle.