Tools Required

J 36721 Front Caliper Bracket Torx Bit

1. Remove the caliper. Refer to Front Brake Caliper Replacement .



2. Remove the caliper mounting bracket bolts (1) using the J 36721 .
3. Remove the caliper mounting bracket.



4. Remove the bushings (2) from the mounting bracket.
5. Inspect the bracket (1) for cracks. Replace the bracket if necessary.

Caution: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.

1. Lubricate the new bushings (2) with silicone grease.



2. Install the bushings (2) into the anchor bracket (1).




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the caliper mounting bracket with the mounting bolts (1) using the J 36721 .

Tighten
Tighten the caliper bracket mounting bolts to 185 N·m (137 lb ft).

4. Install the caliper. Refer to Front Brake Caliper Replacement .