Removal Procedure
- Remove the air cleaner and duct assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.1L.
- Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
- Remove the compressor hose nut (1) from the accumulator and position the line aside.
- Remove the suction line nut (1) from the accumulator and position the line aside.
- Remove the accumulator bracket bolt and the accumulator.
- Remove and discard the O-ring seals on the compressor hose and the suction line.
Installation Procedure
- Install the accumulator and the bracket bolt.
- Install the new O-ring seals onto the compressor hose and the suction line. Refer to O-Ring Replacement .
- Install the suction line and nut (1) onto the accumulator
- Install the compressor hose and nut (1) onto the accumulator.
- Evacuate and charge the system. Refer to Refrigerant Recovery and Recharging .
- Inspect the system for leaks. Refer to Leak Testing .
- Install the air cleaner and duct assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.1L.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the accumulator bracket bolt to 4 N·m (36 lb in).
Important: Lubricate the new O-ring seals and seal washers with a mineral base 525 viscosity refrigerant oil.
Tighten
Tighten the suction line nut to 47 N·m (35 lb ft).
Tighten
Tighten the compressor hose nut to 16 N·m (12 lb ft).
