- Remove the key from the ignition switch.
- Connect the passenger yellow 2-way connector located behind the IP compartment
door.
- Install the Connector Position Assurance
(CPA) to the passenger yellow 2-way connector located behind the IP compartment
door.
- Connect the driver yellow 2-way connector located at the base of the steering
column.
- Install the Connector Position Assurance
(CPA) to the driver yellow 2-way connector located at the base of the steering column.
- Install
the sound insulator-RH. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel, Gauges and Console.
- Install the sound insulator-LH. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel, Gauges
and Console.
- Install Fuse 21 to the IP fuse block.
- Install the IP fuse block door.
- Staying well away from both air bags, turn the ignition switch to the
RUN position.
10.1. | The AIR BAG warning lamp will flash seven times. |
10.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the
Diagnostic System Check - SIR
if the
AIR BAG warning lamp does not operate as described.