Armrest Pull Cup Replacement Front

Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

Important: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.

Important: Use protective coating/tape at the point of insertion of the flat surface tool.

1. Remove the front door armrest pull cup screw.
2. Remove the door armrest pull cup by prying upwards on the rear of the pull cup.
3. Remove the electrical connectors, if equipped.

1. Connect the electrical connectors, if equipped.
2. Install the door armrest pull cup.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the door armrest pull cup screw.

Tighten
Tighten the armrest pull cup screw to 3 N·m (30 lb in).

Armrest Pull Cup Replacement Rear

1. Remove the door armrest pull cup screw.
2. Remove the door armrest pull cup from the door.

1. Install the pull cup in the door

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the door armrest pull cup screw.

Tighten
Tighten the armrest pull cup screw to 3 N·m (30 lb in).