GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Lumina 🢒 Body and Accessories 🢒 Body Rear End 🢒 Fuel Tank Filler Pipe Housing Replacement

Removal Procedure
  1. Remove the fuel filler cap.

    2. Object Number: 291920 Size: SH
  2. Remove the bolts that secure the filler pocket (2) to the fuel filler neck.
  3. Use a flat-bladed tool to release the tabs holding the pocket in place.
  4. Remove the fuel filler pocket (2).

Installation Procedure

    Object Number: 291920 Size: SH
  1. Apply pressure at the top and the bottom edges of the pocket (2). Snap the fuel filler pocket (2) into place.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolts that secure the filler pocket to the fuel filler neck.

    3. Tighten
    Tighten the fuel filler pocket to fuel neck bolts to 1.5 N·m (13 lb in).

  3. Install the fuel filler cap.