SER. MANUAL UPDATE-SEC.8C INSTRUMENT PANEL & GAUGES. Chevrolet Lumina APV 1990

TRANSMISSION TYPE DIVS INVL 1 2 3 7

THIS BULLETIN HAS BEEN REVISED TO CLARIFY THE PROCEDURES.

SERVICE MANUAL UPDATE

SECTION 8C

THE FOLLOWING PROCEDURE IS THE CORRECT REMOVAL AND INSTALLATION OF I/P TRIM PAD FOR THE 1990 U-VAN. THIS PROCEDURE REPLACES THE EXISTING PROCEDURE FOUND ON THE FOLLOWING PAGES:

1990 CHEVROLET LUMINA APV PAGE 8C-12 TO 8C-13 FIGURE 22

INSTRUMENT PANEL PAD ASSEMBLY

A. REMOVE OR DISCONNECT

1. I/P CLUSTER HOUSING AND CLUSTER ASSEMBLY, REFER TO SECTION 8C OF THE 1990 SERVICE MANUAL.

2. SIDE WINDOW DEFROSTER VENT GRILLES (2), TO ACCESS RETAINING SCREWS (2).

3. I/P PAD RETAINING SCREWS (4), TWO THROUGH GLOVE COMPARTMENT (VIEW A), TWO AT I/P CLUSTER BASE.

4. DAYTIME RUNNING LAMP SENSOR FROM LH SPEAKER GRILLE (CANADA ONLY).

5. LIFT I/P PAD UP AND PULL REARWARD TO DISENGAGE RETAINING TABS AT FRONT OF PAD.

6. I/P PAD ASSEMBLY FROM VEHICLE.

INSTALL OR CONNECT

1. POSITION I/P PAD TO LOWER I/P PAD ASSEMBLY, PUSH TO ENGAGE RETAINING TABS AT FRONT OF PAD.

2. DAYTIME RUNNING LAMP SENSOR TO LH SPEAKER GRILLE (CANADA ONLY).

3. I/P PAD RETAINING SCREWS (4) TWO AT I/P CLUSTER BASE, TWO THROUGH GLOVE COMPARTMENT (VIEW A).

4. RETAINING SCREWS AT SIDE WINDOW DEFROSTER OUTLETS AND AMD DEFROSTER GRILLES.

5. I/P CLUSTER ASSEMBLY AND HOUSING, REFER TO SECTION 8C IN THE 1990 SERVICE MANUAL.

1990 PONTIAC TRANS SPORT PAGE 8C-12 FIGURE 22 1990 OLDSMOBILE SILHOUETTE PAGE 8C-11 FIGURE 19 ----------------------------------------------------

I/P PAD ASSEMBLY

A. REMOVE OR DISCONNECT

1. SIDE WINDOW DEFROSTER VENT GRILLES (2), TO ACCESS RETAINING SCREWS (2).

2. I/P TRIM PAD RETAINING SCREWS (4) TWO AT TOP OF I/P CLUSTER, TWO THROUGH GLOVE COMPARTMENT (VIEW A).

3. DAYTIME RUNNING LAMP SENSOR FROM LH SPEAKER GRILLE (PONTIAC VEHICLE ONLY, FOR CANADA ONLY).

4. LIFT I/P PAD UP AND PULL REARWARD TO DISENGAGE RETAINING TABS AT FRONT OF PAD.

5. I/P PAD ASSEMBLY FROM VEHICLE.

B. INSTALL OR CONNECT

1. POSITION I/P PAD TO LOWER I/P PAD, PUSH TO ENGAGE RETAINING TABS.

2. DAYTIME RUNNING LAMP SENSOR TO LH SPEAKER GRILLE (PONTIAC VEHICLE ONLY, FOR CANADA ONLY).

3. I/P TRIM PAD RETAINING SCREWS (4) TWO AT TOP OF CLUSTER, TWO THROUGH GLOVE COMPARTMENT (VIEW A).

4. RETAINING SCREWS AT SIDE WINDOW DEFROSTER OUTLETS AND GRILLES

Object Number: 79007 Size: FS

Object Number: 81427 Size: FS

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.