SOME OWNERS MAY COMMENT THAT THE POWER SLIDING SIDE DOOR WILL NOT OPEN WHEN USING THE INSIDE OR OUTSIDE HANDLE, OR THE KEY CHAIN TRANSMITTER (KEY FOB).
INTERFERENCE BETWEEN INNER PANEL AND OUTSIDE DOOR HANDLE ROD.
1. REMOVE POWER SLIDING SIDE DOOR TRIM PANEL.
2. SEE FIGURE 1 - ITEM 1 FOR INTERFERENCE. IF INTERFERENCE IS PRESENT, PROCEED TO STEP 3.
3. REMOVE OUTSIDE HANDLE ROD. WITH THE ROD REMOVED, CREATE BEND IN ROD AS SHOWN IN FIGURE 1 - ITEM 2. BEND ROD 5MM (3/8 INCH) AT INTERFERENCE FOR CLEARANCE.
4. INSERT REAR SIDE DOOR OUTSIDE HANDLE ROD THROUGH ACCESS HOLE IN DOOR INNER PANEL.
5. SNAP FRONT END OF HANDLE ROD INTO OUTSIDE HANDLE ASSEMBLY.
6. SNAP CENTER OF HANDLE ROD INTO ROD GUIDE.
7. PULL ROD LIGHTLY REARWARD TO REMOVE ALL SLACK FROM SYSTEM, INSURING OUTSIDE HANDLE IS CENTERED.
8. POSITION THREADED END INTO LATCH CLIP AND SNAP CLIP CLOSED TO SECURE.
9. CHECK OPERATION OF THE DOOR.
10. REINSTALL DOOR TRIM.
FOR VEHICLES REPAIRED UNDER WARRANTY, USE:
LABOR OPERATION NUMBER: B5030 USE PUBLISHED LABOR OPERATION TIME.
FIGURES: 01 ATTACHMENTS: 00
FIGURE 1: 1. INTERFERENCE IN THIS LOCATION 2. BEND ROD 5MM (3/8 INCH) AT INTERFERENCE FOR CLEARANCE
GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.
COPYRIGHT 1996 GENERAL MOTORS CORPORATION. ALL RIGHTS RESERVED.