Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Ignition | 1 | 1 | -- | -- |
Backup Lamp Control | 1 | 1 | 1 | -- |
Ground | -- | 1 | -- | -- |
1. Inside Electrochromic Mirror Malfunction | ||||
Circuit/System Description
The inside rearview mirror uses 2 photocell sensors. One sensor is the rear light sensor, located on the face side of the mirror, facing the rear of the vehicle. The rear light sensor is used to determine light conditions present at the mirror face. The other sensor is the front light sensor, located on the backside of the mirror, facing the front of the vehicle. The front light sensor is used to determine the exterior light conditions at the front of the vehicle. With a low exterior light condition detected by the front light sensor and a high light condition from the rear light sensor, the inside rearview mirror will automatically darken the face of the inside rearview mirror.
With the gear selector lever in the REVERSE position, backup lamp control voltage is supplied as an input to the inside rearview mirror. The mirror monitors this input to disable the automatic day-night feature. This allows the driver to see objects in the mirror clearly when backing up, regardless of the rear light sensor status.
Reference Information
Schematic Reference
Inside Rearview Mirror Schematics
Connector End View Reference
Description and Operation
Inside Rearview Mirror Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition ON, headlamps ON, vehicle in PARK, cover the front light sensor with a towel or other suitable item. Shine a flashlight at the rear light sensor while observing the inside rearview mirror face. The inside rearview mirror face should dim.
- Place the transmission in REVERSE. The inside rearview mirror face should transition from dim to bright.
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the inside rearview mirror.
- Wait 1 minute, test for less than 10 Ω between the ground circuit terminal 8 and ground.
- Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 13 and ground.
- Ignition ON, park brake applied, vehicle in REVERSE, verify that a test lamp illuminates between the backup lamp control circuit terminal 9 and ground.
- If all circuits test normal, test or replace the inside rearview mirror.
| ⇒ | If greater than the specified range, test the ground circuit for an open/high resistance. |
| ⇒ | If the test lamp does not illuminate test the ignition circuit for an open/high resistance or short to ground. |
| ⇒ | If the test lamp does not illuminate test the control circuit for an open/high resistance or short to ground. If the circuit tests normal, refer to Backup Lamps Malfunction. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
