GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Lumina VE 🢒 Transmission 🢒 Automatic Transmission - 4L60-E/4L65-E/4L70-E 🢒 Park/Neutral Position Switch Adjustment

Park/Neutral Position Switch Adjustment LHD

    Caution: Refer to Safety Glasses Caution in the Preface section.

    Caution: Refer to Vehicle Lifting Caution in the Preface section.

  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.

    2. Object Number: 1362044 Size: SH
  2. install the PNP switch on the transmission.
  3. Install the PNP switch retaining bolts (6) finger tight only at this time.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the selector lever and nut on the manual selector shaft.

    5. Tighten
    Tighten the retaining nut to 25 N·m (18 lb ft).

  5. Slightly rotate the PNP switch back and forth until a central position is obtained, then lightly tighten the front bolt.
  6. Connect the PNP switch electrical connector (2).
  7. Install the PNP wiring harness electrical connector, do not install the securing pin at this time.
  8. Ensure that the engine can only be started in the Park and Neutral positions. Adjust the switch as necessary.
  9. Tighten the retaining bolts.

    10. Tighten
    Tighten the retaining bolts to 25 N·m (18 lb ft).

  10. Compress the electrical connector release clip, then install the securing pin.
  11. Lower the vehicle.
  12. Ensure that the engine can only be started in the Park and Neutral positions.
  13. Check the reverse lamps for proper operation.