GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 1999 🢒 Malibu 🢒 Engine 🢒 Engine Controls - 3.1L (LG8) 🢒 Accelerator Control Cable Replacement

Removal Procedure

    Object Number: 14159 Size: SH
  1. Remove the left instrument panel sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
  2. Disconnect the accelerator cable from the accelerator pedal.
  3. Squeeze the accelerator cable cover tangs and push the accelerator cable through the bulkhead.

    4. Object Number: 12735 Size: SH
  4. Remove the accelerator cable shield, if equipped.
  5. Remove the accelerator cable from the retaining clip.
  6. Disconnect the accelerator cable from the throttle body lever.
  7. Disconnect the accelerator cable from the accelerator cable bracket.

    8. Object Number: 12734 Size: SH
  8. Remove the accelerator cable from vehicle noting cable routing.

Installation Procedure

    Object Number: 12734 Size: SH

    Notice: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

  1. Install accelerator cable into car using routing noted during removal.

    2. Object Number: 14159 Size: SH
  2. Install the snap retainer through the bulkhead.
  3. Install the accelerator cable through the slot in the accelerator pedal lever.
  4. Seat the snap retainer in the accelerator pedal lever.

    5. Object Number: 12735 Size: SH
  5. Connect the accelerator cable to the throttle body lever.
  6. Connect the accelerator cable to the accelerator cable bracket.
  7. Reinstall the accelerator cable into the retaining clip.
  8. Reinstall the left instrument panel sound insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.