Removal Procedure
- Disconnect the negative battery cable.
- Support the engine by the oil pan. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the engine mount assembly to engine mount bracket support bolts.
- Remove the engine mount to body fasteners.
- Remove the engine mount assembly.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Installation Procedure
- Install the engine mount assembly.
- Install the body fasteners to the engine mount.
- Install the engine mount bracket support bolts to the engine mount.
- Remove the floor jack.
- Connect the negative battery cable.
Tighten
| • | Tighten the bolt to 130 N·m (96 lb ft). |
| • | Tighten the nut to 66 N·m (49 lb ft). |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolt to 130 N·m (96 lb ft).
