Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

1. Hosit the vehicle.



2. Disconnect the CKP sensor harness electrical connector at the CKP sensor.
3. Remove the CKP sensor to engine block bolt.
4. Remove the CKP sensor from the engine block.

Important: Inspect the CKP sensor O-ring for the following condition(s):

1. Install the CKP sensor into the engine block.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the CKP sensor to engine block bolt.

Tighten
Tighten the bolt to 10 N·m (88 lb in).

3. Connect the CKP sensor harness electrical connector.
4. Lower the vehicle.
5. Preform the Crankshaft Position System Variation Learn .