Circuit Description
DTC C1295 identifies open brake switch circuitry that prevents the brake switch input to the EBCM from changing states while applying the brake.
Conditions for Setting the DTC
| • | DTC C1295 can set after initialization is complete. |
| • | A malfunction exists if the brake switch input voltage is out of specification for one second. An open circuit exists when the brake switch input voltage is out of specification. |
Action Taken When the DTC Sets
| • | A malfunction DTC stores. |
| • | ABS disables. |
| • | The ABS warning indicator turns ON. |
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists and the Scan Tool Clear DTCs function is used. |
| • | 100 drive cycles pass with no DTCs detected. A drive cycle consists of starting the vehicle, driving the vehicle over 16 km/h (10 mph), stopping and then turning the ignition off. |
Diagnostic Aids
The following conditions may cause an intermittent malfunction:
| • | A poor connection |
| • | Rubbed-through wire insulation |
| • | A broken wire inside the insulation |
Use the enhanced diagnostic function of the Scan Tool in order to measure the frequency of the malfunction.
Thoroughly inspect any circuitry that may cause the intermittent complaint for the following conditions:
| • | Backed out terminals |
| • | Improper mating |
| • | Broken locks |
| • | Improperly formed or damaged terminals |
| • | Poor terminal-to-wiring connections |
| • | Physical damage to the wiring harness |
Test Description
-
This test confirms that an open in the brake switch circuit currently exists.
-
This test checks for an open in the brake switch circuit.
Step | Action | Value(s) | Yes | No | ||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Important: Zero the J 39200 test leads before making any resistance measurements. Refer to the J 39200 user's manual. | ||||||||||
1 | Was the ABS Diagnostic System Check performed? | -- | ||||||||
Do not start the engine. Does the Scan Tool indicate that the brake switch circuit is open? | -- | |||||||||
3 | Apply light pressure to the brake pedal while monitoring the Brake Switch Position on the Scan Tool . Does the Scan Tool indicate that the brake switch is on within 25 mm (1.0 in) of the brake pedal travel? | -- | ||||||||
4 |
Are the rear brake lamps on? | -- | ||||||||
Do not start the engine. Is the voltage equal to or greater than the specified voltage? | 10.0 V | |||||||||
6 | Inspect the EBCM connector and the EBCM harness connector for the following conditions:
Are poor terminal contact, terminal corrosion or damaged terminals evident? | -- | ||||||||
7 | Repair the open in CKT 20. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | -- | |||||||
8 | Replace all the terminals or the connectors that exhibit the following conditions:
Is the repair complete? | -- | -- | |||||||
9 | Repair the open brake lamp circuit wiring. Refer to Stop Lamps Inoperative in Lighting Systems. Is the repair complete? | -- | -- | |||||||
10 | Replace the EBCM. Refer to Electronic Brake Control Module Replacement . Is the repair complete? | -- | -- | |||||||
11 | The malfunction is intermittent or is not present at this time. Refer to Diagnostic Aids for more information. Is the action complete? | -- | System OK | -- | ||||||
