Circuit Description
This is the hardware Ignition 1, CKT 439, input to the body control module (BCM) from the Ignition Switch.
Conditions for Setting the DTC
All of the following conditions must be met.
| • | The Ignition 1 input is not active. |
| • | The Ignition 3 is active for twenty seconds. |
Action Taken When the DTC Sets
The BCM stores DTC B1374 in memory.
Conditions for Clearing the DTC
| • | The BCM goes to sleep. The BCM reinitializes with the fault cleared. |
| • | All BCM history codes will be cleared after 100 ignition cycles (from OFF to RUN) with no current codes active during the 100 ignition cycles. |
| • | Use the Scan Tool. |
Diagnostic Aids
| • | This has no effect upon the BCM. |
| • | The Electronic Brake Control Module (EBCM) will not communicate with the scan tool if Ignition 1 input is not active. |
| • | If the DTC is a history DTC, the problem may be intermittent. Perform the tests shown while wiggling the wiring and connectors. This can often cause the malfunction to appear. |
Test Description
The numbers listed below refer to the numbers on the diagnostic table.
-
This step determines if CKT 439 is delivering power to the body control module (BCM).
-
This step determines if there is an open in CKT 439 between the BCM and the underhood wiring harness junction block.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
|
Important: A short to ground will cause an open fuse(s). Before performing this diagnostic procedure, inspect the fuse(s) for an open. | ||||
1 | Was the BCM System Check performed? | -- | Go to Step 2 | |
Is the measured voltage within the specified range? | B+ | Go to Step 3 | Go to Step 6 | |
3 | Inspect for a poor connection at the body control module BCM harness connector C2 terminal B9. Was there a poor connection found? | -- | Go to Step 4 | Go to Step 5 |
4 | Repair the poor connection. Refer to Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 11 | -- |
5 | Replace the BCM. Refer to the following procedures: Is the repair complete? | -- | Go to Step 11 | -- |
6 |
Is the measured resistance within the specified range? | 0-2 ohms | Go to Step 8 | Go to Step 7 |
7 | Repair an open in CKT 439 between the BCM connector C2 terminal B9 and the underhood wiring harness junction block connector C3 terminal C4. Refer to Wiring Repairs in Wiring Systems. Is the circuit repair complete? | -- | Go to Step 11 | -- |
8 | Inspect for a poor connection at the underhood wiring harness junction block connector C3 terminal C4. Was a poor connection found? | -- | Go to Step 9 | Go to Step 10 |
9 | Repair the poor connection at the underhood wiring harness junction block connector C3 terminal C4, CKT 439. Refer to Wiring Repairs in Wiring Systems. Is the circuit repair complete? | -- | Go to Step 11 | -- |
10 | Replace the underhood wiring harness junction block. Refer to Underhood Fuse Block Replacement in Engine Electrical. Is the repair complete? | -- | Go to Step 11 | -- |
11 | Clear the DTCs from the memory. Are the DTCs cleared from the memory? | -- | -- | |
