Removal Procedure
- Disable the SIR system. Refer to
Disabling the SIR System
.
- Remove the 2 screws from the back of the steering wheel.
- Disconnect the following components from the rear of the inflator
module:
| • | The connector position assurance (CPA) |
| • | The electrical connection |
- Remove the inflator module (1).
- Fully deploy the module before disposal. If the module was replaced
under warranty, fully deploy and dispose of the module after the required
retention period. Refer to
Inflator Module Handling, Shipping, and Scrapping
.
Installation Procedure
- Connect the following
components to the rear of the inflator module:
| • | The connector position assurance (CPA) |
| • | The electrical connection |
- Install the inflator module (1) to the steering wheel (3).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the 2 screws through the back of the steering wheel (3).
Tighten
Tighten the screws to 10 N·m (89 lb in).
- Enable the SIR system. Refer to
Enabling the SIR System
.
