GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 12735  Size: SH
  1. Turn OFF the ignition.
  2. Disconnect the accelerator cable from throttle body.
  3. Depress the tangs and remove the accelerator cable from accelerator cable bracket.

  4. Object Number: 319387  Size: SH
  5. If applicable disconnect the cruise control cable from the throttle lever and accelerator bracket.
  6. Unsnap wire harness clip from bracket.

  7. Object Number: 12689  Size: SH
  8. Remove the nuts and bolts holding the accelerator cable bracket to the throttle body.
  9. Remove the accelerator cable bracket.

Installation Procedure


    Object Number: 12689  Size: SH
  1. Install the accelerator cable bracket to throttle body.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the accelerator cable bracket retaining nuts and bolts.
  4. Tighten

        • Tighten the nuts to 10 N·m (89 lb in).
        • Tighten the bolts to 13 N·m (115 lb in).
  5. Install the wire harness clip.

  6. Object Number: 12735  Size: SH
  7. Connect the accelerator cable into accelerator cable bracket.
  8. Connect the accelerator cable into throttle body .

  9. Object Number: 319387  Size: SH
  10. If applicable connect the cruise control cable to the throttle lever and accelerator cable bracket.