Removal Procedure
- Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls.
- Disconnect and position aside the underhood electrical center from the bracket. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems.
- Remove the underhood electrical center bracket.
- Remove the master cylinder (2) from the hydraulic brake booster (1). Refer to Master Cylinder Replacement .
- Disconnect the vacuum hose and the vacuum brake booster check valve (1) from the booster as an assembly.
- Remove the left Closeout/Insulator Panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
- Remove the booster retaining nuts (2).
- Disconnect the booster pushrod (1) from the brake pedal (2).
- Remove the booster from the vehicle.
Careful not lose or dislodge the insulator between the booster and the front of the dash.
Tilt the vacuum brake booster slightly in order to work the booster pushrod off the pedal clevis pin. Do not apply excessive side pressure on the pushrod.
Installation Procedure
- Install the booster to the vehicle.
- Install the booster pushrod (1) to the brake pedal (2).
- Install the booster retaining nuts (2).
- Install the left Closeout / Insulator Panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
- Connect the vacuum hose and the vacuum brake booster check valve (1) to the booster as an assembly.
- Install the master cylinder (2) to the booster (1).
- Install the master cylinder. Refer to Master Cylinder Replacement .
- Install the underhood electrical center bracket.
- Position back and connect the underhood electrical center. Refer to Underhood Electrical Center or Junction Block Replacement in Wiring Systems.
- Install the cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls.
Tilt the vacuum brake booster slightly in order to work the booster pushrod onto the pedal clevis pin. Do not apply excessive side pressure on the pushrod. Align the pushrod with the pedal and assemble.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the booster to brake pedal retaining nuts to 27 N·m
(20 lb ft).
