Cruise control is a speed control system that maintains a desired vehicle speed under normal driving conditions at speeds above 40 km/h (25 mph). However, steep grades may cause variations in the selected speeds.

The main components of the cruise control system are:

The cruise control module controls the operation of the cruise control system. The cruise control module assembly has an electronic controller and an electric stepper motor to vary the throttle in each different cruise control mode. The electric controller monitors vehicle speed and operates the electric stepper motor. The stepper motor operates in response to the electronic controller, to maintain the desired cruise speed. The electric stepper motor moves a strap that is attached to the cruise control cable which moves the throttle linkage.

The operation of the electronic controller is controlled by the function control switches located on the steering wheel. The cruise control functional control switches include the ON/OFF, SET/COAST and R/A (resume/accelerate) switch. The switch assembly provides driver control of the cruise control system.

The TCC/Brake switch and stop lamp switch control the cruise control release signal and the stop lamp signal. These signal circuits are used to disengage the cruise control. The switch assemblies are mounted on the brake pedal bracket. To disengage the system electrically the driver presses the brake pedal. The speed of the vehicle at brake actuation will be stored in the memory of the cruise module.

The vehicle speed stored in the memory of the cruise module will be lost.

Ignition positive voltage is supplied from the cruise fuse, to the cruise control module. The cruise control switch is supplied ignition positive voltage by the cruise switch fuse. The cruise control module is grounded to the chassis. When the cruise control ON/OFF switch is on, ignition positive voltage is applied to the cruise on switch signal circuit of the cruise control module. If the driver has not pressed the brake pedal, ignition positive voltage is supplied through the cruise control release circuit to the cruise control release signal terminal of the cruise control module. On vehicles equipped with a manual transmission, a clutch switch is wired in series on this circuit and operates the same. When the driver presses the brake pedal, battery positive voltage is supplied from the stop lamp fuse, through the closed stop lamp switch to the stop lamp switch signal terminal of the cruise control module. As this operation occurs, ignition positive voltage is removed from the cruise release signal circuit. If equipped, voltage is also removed from the cruise release signal circuit when the clutch pedal is pressed. When SET/COAST is pressed on the control switch, ignition positive voltage is applied to the set/coast switch signal terminal of the cruise control module. When pressing the R/A (resume/accelerate) on the control switch, ignition positive voltage is applied to the resume/accelerate switch signal terminal of the cruise control module.

The cruise control module receives a vehicle speed signal input from the powertrain control module (PCM). In operation, the voltage varies between 0 V and 5 V.

The cruise control module, cruise engaged terminal, sends a signal to the PCM when cruise is engaged. The cruise control module, cruise cancel signal terminal, is a circuit used by the PCM to inhibit cruise control when conditions inconsistent with cruise operation are present.

After the cruise control engage criteria has been met and the cruise control ON and Set/Coast have been commanded, the cruise control module sends a signal to the PCM that the cruise control is engaged. The PCM sends a class 2 message to the BCM that the cruise control is engaged. The BCM sends a message to the instrument panel cluster (IPC) to illuminate the cruise indicator if equipped.

The PCM inhibits cruise control when.

When any of the conditions listed above are present, the PCM removes the ground from the cruise control inhibit signal circuit. The cruise control module monitors the cruise control inhibit circuit in order to disable the system.The PCM compares the status of the cruise control inhibit signal circuit to the status of the cruise control engaged signal circuit. If the cruise control engaged signal circuit indicates that the cruise control module has cruise control engaged while the PCM is inhibiting cruise control operation,the PCM sets a DTC.