- Wash the panel using soap and water.
- Wipe the panel dry.
- Use a clean rag and 3M General Purpose Adhesive Cleaner 08984
or the equivalent in order to wipe the panel and the adhesive side of the
emblem/nameplate (2).
- Use a clean rag and an alcohol/water mixture to remove
residue from the following components:
Notice: If tape is still intact on the molding or panel, do not remove the tape.
Clean the tape and the mating surface with Adhesive Cleaner. Wipe the tape
and mating surface with a clean, soft cloth. If the tape is damaged, refer
to Emblem/Nameplate Replacement.
- Apply a length of masking tape or a magnetic strip as a guide, if needed.
Important: Use the minimum amount of adhesive required. Adhesive drips or squeeze-out
may cause paint discoloration.
- Apply a thin film of adhesive to the back of the emblem/nameplate (2).
- Press the piece into place.
If you use the LOCTITE™ 414 adhesive GM P/N 1052621
or the equivalent, apply constant pressure to the molding for 30 seconds
or until a firm bond has been made.
