Power Door Lock Key Cylinder Switches Inoperative. Chevrolet Malibu 2004

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2004 🢒 Malibu 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 Power Door Lock Key Cylinder Switches Inoperative

Step	Action	Yes	No
Schematic Reference: Door Lock/Indicator Schematics Connector End View Reference: Power Door Systems Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Verify that the power door locks key cylinder switches are inoperative. Does the power door locks key cylinder switches system operate normally?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Does the power door locks system operate normally?	Go to Step 4	Go to Symptoms - Doors
4	Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Door Cylinder Switch parameter in the body control module (BCM) data list. Does the scan tool display Idle?	Go to Step 5	Go to Step 6
5	Activate the key cylinder switch to the Lock and Unlock positions. With a scan tool, observe the Door Cylinder Switch parameter in the BCM data list. Does the scan tool display Idle in both positions?	Go to Step 7	Go to Step 8
6	Test the appropriate door lock key switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 13	Go to Step 9
7	Test the ground circuit of the driver door lock actuator for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 13	Go to Step 9
8	Test the appropriate door lock key switch signal circuit for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 13	Go to Step 10
9	Inspect for poor connections at the harness connector of the driver door lock actuator. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 13	Go to Step 11
10	Inspect for poor connections at the harness connector of the body control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 13	Go to Step 12
11	Replace the driver door lock actuator. Refer to Front Side Door Lock Replacement . Did you complete the replacement?	Go to Step 13	--
12	Perform the set-up procedure for the body control module. Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems. Replace the body control module. Refer to Body Control Module Replacement in Computer/Integrating Systems. Did you complete the replacement?	Go to Step 13	--
13	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2