Schematic Reference: Brake Warning System Schematics

Connector End View Reference: Hydraulic Brake Connector End Views

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle in Vehicle DTC Information

With the scan tool comand the IPC indicators ON

Does the red Brake indicator illuminate during the test?

Go to Step 3

Go to Step 15

Apply the park brake.

Does the red Brake indicator illuminate?

Go to Step 4

Go to Step 5

1. Turn OFF the ignition.
2. Release the park brake.
3. Disconnect the brake fluid level switch.
4. Connect a 3-amp fused jumper wire between the signal circuit of the brake fluid level switch and a the ground circuit of the brake fluid level switch.
5. Turn ON the ignition, with the engine OFF.

Does the red Brake indicator illuminate?

Go to Step 10

Go to Step 7

1. Turn OFF the ignition.
2. Disconnect the park brake switch.
3. Connect a 3-amp fused jumper wire between the signal circuit of the park brake switch and a good ground.
4. Turn ON the ignition, with the engine OFF.

Does the red Brake indicator illuminate?

Go to Step 9

Go to Step 6

Test the signal circuit of the park brake switch for a high resistance or a open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 11

Test the signal circuit of the brake fluid level switch for a high resistance or a open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 8

Test the ground circuit of the brake fluid level switch for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 11

Inspect for poor case ground or poor connections at the harness connector of the park brake switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 12

Inspect for poor connections at the harness connector of the brake fluid level switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 13

Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 14

Replace the park brake switch. Refer to Parking Brake Indicator Switch Replacement in Park Brake.

Did you complete the repair?

Go to Step 16

--

Replace the brake fluid level switch. Refer to Brake Fluid Level Indicator Switch Replacement .

Did you complete the repair?

Go to Step 16

--

Replace the BCM. Refer to Body Control Module Replacement in Computer/Integrating Systems.

Did you complete the repair?

Go to Step 16

--

Replace the IPC. Refer to Instrument Cluster Replacement in Computer/Integrating Systems.

Did you complete the repair?

Go to Step 16

--

Operate the vehicle in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2