GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the instrument panel (I/P) cluster. Refer to Instrument Cluster Replacement .
  2. Remove the knee bolster. Refer to Knee Bolster Replacement .
  3. Remove the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  4. Remove the ignition switch wire harness connector.
  5. Remove the theft deterrent control module wire harness connector.
  6. Remove the ignition switch lock cylinder. Refer to Ignition Switch Lock Cylinder Replacement .
  7. Disconnect the park lock cable at the ignition switch. Refer to Park Lock Cable Replacement in Automatic Transaxle - 4T40-E/4T45-E.
  8. Remove the ignition switch at the I/P screws.

  9. Object Number: 1207704  Size: SH
  10. Remove the ignition switch assembly.
  11. Remove the ignition switch bracket screws.
  12. Remove the theft deterrent control module. Refer to Theft Deterrent Module Replacement in Theft Deterrent.

  13. Object Number: 1207709  Size: SH
  14. Remove the ignition switch bracket.

Installation Procedure


    Object Number: 1207709  Size: SH
  1. Install the ignition switch bracket.
  2. Install the theft deterrent control module. Refer to Theft Deterrent Module Replacement in Theft Deterrent.
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the ignition switch bracket screws.
  5. Tighten
    Tighten the screws to 5 N·m (44 lb in).


    Object Number: 1207704  Size: SH
  6. Install the ignition switch .
  7. Tighten the ignition switch screws.
  8. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  9. Connect the park lock cable at the ignition switch. Refer to Park Lock Cable Replacement in Automatic Transaxle - 4T40-E/4T45-E.
  10. Install the theft deterrent control module wire harness connector.
  11. Install the ignition switch wire harness connector.
  12. Install the ignition switch lock cylinder. Refer to Ignition Switch Lock Cylinder Replacement .
  13. Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  14. Install the knee bolster. Refer to Knee Bolster Replacement .
  15. Install the I/P cluster. Refer to Instrument Cluster Replacement .