Evaporative Emission Canister Vent Solenoid Valve Replacement Malibu Sedan

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Lower the fuel tank enough on the RH side to access the purge valve. Refer to Fuel Tank Replacement . It is not necessary to fully remove the fuel tank from the vehicle



3. Disconnect the evaporative emission (EVAP) vent valve electrical connector.
4. Remove the vent hose.
5. Depress the locking tab on the EVAP vent valve mount and slide the valve rearward off of the fuel tank.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the EVAP canister vent valve on the mount on the fuel tank, push the valve forward until the locking tab engages.

Tighten
Tighten the bolt to 10 N·m (89 lb in).

2. Connect the vent hose.
3. Connect the electrical connector.
4. Install the fuel tank Refer to Fuel Tank Replacement .
5. Lower the vehicle.

Evaporative Emission Canister Vent Solenoid Valve Replacement Malibu MAXX

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Lower the fuel tank enough on the RH side to access the purge valve. Refer to Fuel Tank Replacement . It is not necessary to fully remove the fuel tank from the vehicle



3. Disconnect the evaporative emission (EVAP) vent valve electrical connector.
4. Remove the vent hose.
5. Depress the locking tab on the EVAP vent valve mount and slide the valve rearward off of the fuel tank.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the EVAP canister vent valve on the mount on the fuel tank, push the valve forward until the locking tab engages.

Tighten
Tighten the bolt to 10 N·m (89 lb in).

2. Connect the vent hose.
3. Connect the electrical connector.
4. Install the fuel tank Refer to Fuel Tank Replacement .
5. Lower the vehicle.