GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 39194-B Heated Oxygen Sensor Wrench

Removal Procedure

    Notice: Refer to Heated Oxygen Sensor Resistance Learn Reset Notice in the Preface section.

    Notice: The oxygen sensor may be difficult to remove when the engine temperature is below 48°C (120°F). Excessive force may damage threads in the exhaust manifold or the exhaust pipe.


    Object Number: 1239005  Size: SH
  1. Disconnect the HO2S 1 electrical connector.
  2. Use the J 39194-B to remove the HO2S 1.

Installation Procedure


    Object Number: 1239005  Size: SH

    Important : A special anti-seize compound is used on the HO2S 1 threads. The compound consists of graphite suspended in fluid and glass beads. The graphite will burn away, but the glass beads will remain, making the sensor easier to remove. New or service sensors will already have the compound applied to the threads. If a sensor is removed from an engine and is to be reinstalled, the threads must have anti-seize compound applied before the reinstallation.

  1. Coat the threads of the HO2S 1 with anti-seize compound GM P/N 12377953 or an equivalent, if necessary.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the HO2S 1.
  4. Tighten
    Use the J 39194-B to tighten the sensor to 41 N·m (30 lb ft).

  5. Connect the H02S 1 electrical connector.