Important: Because of how vehicle key information and theft deterrent passwords are stored within the TDM, the Set Up a New Theft Deterrent Module procedure must be performed prior to the removal and replacement of the TDM if the vehicle keys are being reused. Performing the setup procedure first allows the scan tool to extract the key information and passwords from the old TDM prior to its removal. Failure to perform this step will result in the failure to learn the existing vehicle keys and new vehicle keys will be required when replacing the TDM.

1. Remove the ignition switch. Refer to Ignition and Start Switch Replacement .
2. Remove the theft deterrent control module screws.



3. Remove the theft deterrent control module.

1. Install the theft deterrent control module.

Notice: Refer to Fastener Notice in the Preface section.

2. Tighten the theft deterrent control module screws.

Tighten
Tighten the screws to 5 N·m (44 lb in).

3. Install the ignition switch. Refer to Ignition and Start Switch Replacement .
4. Program the theft deterrent control module after replacement. Refer to Control Module References .