GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Malibu 🢒 Vehicle Control Systems 🢒 Computer/Integrating Systems 🢒 Body Control Module Replacement

Removal Procedure
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the right console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Right Side .
  3. Remove the body control module (BCM) screws.
  4. Remove the BCM wire harness connectors.

    5. Object Number: 1207700 Size: SH
  5. Remove the BCM.

Installation Procedure

    Object Number: 1207700 Size: SH
  1. Install the BCM.
  2. Install the BCM wire harness connectors.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the BCM screws.

    4. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  4. Install the right console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Right Side .
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  6. For a new or remanufactured BCM, setup the BCM. Refer to Control Module References .