For 1990-2009 cars only
Removal Procedure
- Open the hood.
- Pull the rear side hood seal, located at the end of the plenum to hood seal, from the air inlet grille panel.
- Remove the seal from the vehicle.
- Clean any adhesive from the air inlet grille panel and the hood hinge bracket using 3M™ P/N 8984.
Installation Procedure
- Remove the protective backing paper from the adhesive on the rear side hood seal.
- With the rear side seal butted to the plenum-to-hood seal, press the side hood seal until the adhesive is fully adhered.
- Close the hood.
