GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Malibu 🢒 Body 🢒 Wiring Systems 🢒 Camshaft Position Sensor Replacement

Removal Procedure

    Object Number: 909619 Size: SH
  1. Disconnect the camshaft position (CMP) sensor electrical connector.
  2. Remove the CMP sensor bolt.
  3. Remove the CMP sensor.
  4. Inspect the sensor O-ring for wear, cracks, or leakage if the sensor is not being replaced.

Installation Procedure
  1. Lubricate the O-ring with clean engine oil and replace the O-ring if damaged.

    2. Object Number: 909619 Size: SH
  2. Install the CMP sensor.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the CMP sensor bolt.

    4. Tighten
    Tighten the bolt to 10 N·m (89 lb in).

  4. Connect the CMP sensor electrical connector.