GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Malibu 🢒 Brakes 🢒 Hydraulic Brakes 🢒 Rear Disc Brake Hardware Replacement

Removal Procedure

    Caution: Refer to Brake Dust Caution in the Preface section.

  1. Inspect the fluid level in the brake master cylinder reservoir.
  2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, then no brake fluid needs to be removed from the reservoir before proceeding. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, then remove brake fluid to the midway point before proceeding.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Using a C-clamp installed to the center of the outer brake pad and the back of the caliper, slowly compress the caliper piston into its bore just enough to remove the caliper from the mounting bracket.

    5. Object Number: 1335465 Size: SH
  5. Remove the 2 brake caliper guide pin bolts.

    6. Notice: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

  6. Remove the brake caliper from the brake caliper mounting bracket.

    7. Object Number: 1335587 Size: SH
  7. Remove the brake pads (1) from the brake caliper mounting bracket (3).
  8. Remove the brake pad retainers (2) from the brake caliper mounting bracket (3).

    9. Object Number: 750472 Size: SH
  9. Remove the brake caliper guide pins (2) from the brake caliper mounting bracket (4).
  10. Remove the caliper pin boots (3) from the brake caliper mounting bracket (4).

Installation Procedure

    Object Number: 750472 Size: SH
  1. Apply a thin coat of high temperature silicone lube to the brake caliper guide pin boots.
  2. Install the brake caliper pin boots (3) to the brake caliper mounting bracket (4).
  3. Apply a thin coat of high temperature silicone lube to the brake caliper guide pins (2).
  4. Install the brake caliper guide pins (2) to the brake caliper mounting bracket (4).

    5. Object Number: 1335587 Size: SH
  5. Install the brake pad retainers (2) to the brake caliper mounting bracket (3).
  6. Install the brake pads (1) to the brake caliper mounting bracket (3).
  7. Install the brake caliper to the brake caliper mounting bracket.

    8. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1335465 Size: SH
  8. Install the 2 brake caliper guide pin bolts.

    9. Tighten
    Tighten the brake caliper guide pin bolts to 35 N·m (26 lb ft).

  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  10. Lower the vehicle.
  11. Fill the master cylinder to the proper level . Refer to Master Cylinder Reservoir Filling .
  12. Pump the brake pedal 2-3 times in order to seat the rear disc brake pads to the rotor.