GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 627406  Size: SH

    Notice: Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause fluid loss.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Position a drain pan under the vehicle.
  3. Remove the oil cooler hoses from the transaxle oil cooler fittings. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  4. Remove the oil cooler fittings (28, 29) from the transaxle.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 627406  Size: SH

    Important: The correct thread engagement is critical. Cross-threaded fittings can achieve proper tightness and still leak.

  1. Install the oil cooler fittings (28, 29) to the transaxle.
  2. Tighten
    Tighten the fittings to 38 N·m (28 lb ft).

  3. Install the oil cooler hoses to the transaxle oil cooler fittings. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  4. Lower the vehicle.
  5. Notice: Refer to Transmission Overfill Notice in the Preface section.

  6. Adjust the fluid level.
  7. Inspect for fluid leaks. Refer to Fluid Leak Diagnosis .
  8. Remove the drain pan from under the vehicle.