Power Steering Pump Flow Control Valve Replacement - Off Vehicle HPS

1. Remove the O-ring union fitting (5) from the hydraulic pump housing assembly (1).
2. Remove the O-ring seal (4) from the O-ring union fitting (5).
3. Remove the control valve assembly (3).
4. Remove the flow control spring (2).

1. Install the flow control spring (2) to the hydraulic pump housing assembly (1).
2. Install the control valve assembly (3).
3. Lubricate the O-ring seal (4) with power steering fluid.
4. Install the O-ring seal (4) onto the O-ring union fitting (5).

Notice: Refer to Fastener Notice in the Preface section.

5. Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).

Tighten
Tighten the fitting (5) to 75 N·m (55 lb ft).