Vibration/Rattle/Buzz Noise from Right Front Side of Dash/Windshield Area at Speeds Above 56 km/h (35 mph) (Install Two-Way Tape)
| Subject: | Vibration/Rattle/Buzz Noise From Right Front Side of Dash/Windshield Area at Speeds Above 56 km/h (35 mph) (Install Two-Way Tape) |
| Models: | 2006-2007 Malibu, Malibu Maxx |
Condition
Some customers may comment on a vibration/rattle/buzz type noise coming from the right side dash/windshield area. The noise will start when the vehicle speeds reach 56 to 64 km/h (35 to 40 mph) and continue up through highway speeds.
Cause
The noise may be coming from the plastic cowl cover screen vibrating and contacting the windshield on the right side of the windshield between the wiper post and the right side "A" pillar. The cover may be raised off the windshield slightly and the air flow as the vehicle is traveling is pushing the cover down, causing the rattle/buzz noise.
Correction
Remove the cowl cover and install a strip of double stick tape to the underside of the cover. Install the tape about 102 mm (4 in) from the wiper post opening to the end of the cover. The tape should be on the plastic cover, not on the seal. Clean the windshield in this area and reinstall the cover. Press the cover down where the tape was installed.
Parts Information
Part Number | Description | Material Allowance |
|---|---|---|
3M 06397 | 3M™ Scotch Mount* | $2.50 (U.S.) $2.93 (Canada) |
*or equivalent
Warranty Information
For vehicles under warranty, use:
Labor Operation | Description | Labor Time |
|---|---|---|
B9814* | Panel, Air Inlet Grille - R&R | 0.5 hr |
*This is a unique labor operation for bulletin use only. It will not be published in the Labor Time Guide. | ||
