GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Malibu 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Brake and Accelerator Pedal Adjuster Position Sensor Replacement

Removal Procedure
  1. Remove the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side.
  2. Remove the intermediate steering shaft bolt and position the intermediate steering shaft away from the steering column in order to gain access to the brake pedal adjustment position sensor. Refer to Intermediate Steering Shaft Replacement.
  3. Disconnect the electrical connector from the brake and accelerator pedal adjustment position sensor.

    4. Object Number: 1698612 Size: SH
  4. Remove the brake and accelerator pedal adjustment position sensor bolt (1) and sensor (2).

Installation Procedure

    Object Number: 1698612 Size: SH

    Important: Ensure that the brake and accelerator pedal adjustment position sensor is installed correctly to the bracket. The brake and accelerator pedal adjustment position sensor has a sensing arm that must be installed over the brake pedal actuation arm to insure it is sensing brake pedal position.

  1. Install the brake and accelerator pedal adjustment position sensor (2) to the brake pedal bracket. Ensure the brake pedal position sensor tab locks into the brake pedal bracket and the sensors arm is correctly installed.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the brake pedal adjustment position sensor bolt (1).

    3. Tighten
    Tighten the bolt to 2 N·m (18 lb in).

  3. Connect the electrical connector to the brake and accelerator pedal adjustment position sensor.
  4. Install the intermediate steering shaft to the steering column. Refer to Intermediate Steering Shaft Replacement.
  5. Install the left side instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side.