GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Malibu 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement - Intake

Removal Procedure

    Object Number: 1890093 Size: SH
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
  2. Disconnect the engine wiring harness electrical connector (7) from the intake camshaft position (CMP) sensor (6).

    3. Object Number: 1578483 Size: SH
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.

Installation Procedure

    Object Number: 1578483 Size: SH

    Important: Inspect the CMP sensor for damage, replace as necessary.

  1. Lubricate the CMP sensor O-ring seal with clean engine oil.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the CMP sensor.
  3. Install the CMP sensor bolt.

    4. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1890093 Size: SH
  4. Connect the engine wiring harness electrical connector (7) to the intake CMP sensor (6).
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.