GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Malibu 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Windshield Washer Pump Replacement

Removal Procedure
  1. Remove the front wheelhouse panel splash shield. Refer to Front Wheelhouse Panel Splash Shield Replacement .

    2. Object Number: 1207514 Size: SH
  2. Disconnect the washer pump electrical connector.
  3. Disconnect the washer pump hose (2) from the washer pump (5).
  4. Using a small flat-bladed tool, remove the washer pump from the washer solvent container (1).
  5. Drain the windshield washer solvent into a clean suitable container.
  6. Using a small flat-bladed tool, remove the washer pump terminal seal (6) from the washer solvent container (1).

Installation Procedure

    Object Number: 1207514 Size: SH
  1. Position the washer pump terminal seal (6) to the washer solvent container (1), pressing in until fully seated.
  2. Using full strength windshield washer solvent as a lubricant on the terminal seal, position the washer pump (5) to the washer solvent container (1) pressing in until fully seated.
  3. Connect the washer pump electrical connector.
  4. Connect the washer pump hose (2) to the washer pump (5).
  5. Install the front wheelhouse panel splash shield. Refer to Front Wheelhouse Panel Splash Shield Replacement .
  6. Fill the washer solvent container with washer solvent.
  7. Inspect the washer system for proper operation.