GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Malibu 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 2 (Left Side) Intake

Removal Procedure

    Object Number: 1839729 Size: SH
  1. Remove the engine mount snubber bracket. Refer to Engine Mount Snubber Bracket Replacement.
  2. Disconnect the engine wiring harness electrical connector (2) from the bank 2 intake camshaft position (CMP) actuator solenoid valve.

    3. Object Number: 1285234 Size: SH
  3. Remove the CMP actuator solenoid valve bolt.
  4. Remove the CMP actuator solenoid valve.
  5. Inspect the CMP actuator solenoid valve seal for damage and replace as necessary.

Installation Procedure

    Object Number: 1285234 Size: SH
  1. Inspect the CMP actuator solenoid valve seal for damage. Replace the seal if necessary.
  2. Install the CMP actuator solenoid valve.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the CMP actuator solenoid valve bolt.

    4. Tighten
    Tighten the bolt to 10 N·m (89 lb in)


    Object Number: 1839729 Size: SH
  4. Connect the engine wiring harness electrical connector (2) to the bank 2 intake CMP actuator solenoid valve.
  5. Install the engine mount snubber bracket. Refer to Engine Mount Snubber Bracket Replacement.