GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Malibu 🢒 Transmission/Transaxle 🢒 Automatic Transaxle - 4T45-E 🢒 Transmission Rear Mount Replacement

Transmission Rear Mount Replacement ME7/MN5

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the left tire and wheel. Refer to Tire and Wheel Removal and Installation.
  3. Using a suitable jack stand, support the rear of the powertrain.

    4. Object Number: 1975902 Size: SH
  4. Remove the transmission mount to bracket through bolt (1).

    5. Object Number: 1975904 Size: SH
  5. Remove the transmission mount to transmission bolts (1).
  6. Remove the transmission mount (2).
  7. Disconnect the HO2 sensor Harness from the transmission mount bracket.

    8. Object Number: 1975906 Size: SH
  8. Remove the transmission mount to frame bolts (1).
  9. Remove the transmission mount bracket (2).

Installation Procedure

    Object Number: 1975906 Size: SH
  1. Install the transmission mount bracket (2).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the transmission bracket to frame bolts (1).

    3. Tighten
    Tighten the bolts to 50 N·m (37 lb ft).

  3. Connect the HO2 sensor harness to the transmission mount bracket.

    4. Object Number: 1975904 Size: SH
  4. Install the transmission mount (2).
  5. Install the transmission mount to transmission bolts (1).

    6. Tighten
    Tighten the bolts to 90 N·m (66 lb ft).


    Object Number: 1975902 Size: SH
  6. Install the transmission mount to bracket through bolt (1).

    7. Tighten
    Tighten the bolt to 90 N·m (66 lb ft).

  7. Remove the jack stand.
  8. Install the left tire and wheel. Refer to Tire and Wheel Removal and Installation.
  9. Lower the vehicle.